How to extend the service life of sawdust pellet machine?

According to the different application industries, pellet machines are divided into many different types, such as straw pellet machines, feed pellet machines, sawdust pellet machines, sawdust pellet machines, etc., which are very common. Straw, sawdust and other biomass raw materials can be made into valuable particles by particle machine equipment, which not only realizes the recycling of resources, but also avoids serious pollution to the environment. (How to extendsawdust pellet machineThe service life of?)

Since the particle machine is so important, how can we extend the service life of the particle machine?

1. Use the matching power according to the instructions. If the power is too small, it will cause low output and poor effect; if the power is too large, it will waste electromechanical, accelerate mechanical wear, and shorten the service life of the equipment.

2. Generally, the moisture of raw materials is controlled40%The following. The water content is too high to be crushed, which increases the impact times of the hammer sheet. At the same time, due to the friction of the material and the heat generated by the hammer sheet, the internal water evaporates, and the evaporated water forms paste with the crushed fine powder to block the screen hole, thus reducing the discharge of the crusher. Too low moisture leads to high hardness of the material and large power consumption during processing, which increases the production cost of the enterprise and reduces the service life of the granulator.

3, the particle machine should be placed in a suitable place to work, as far as possible to reduce the number of moving the particle machine, can be set in the particle machine feed inlet permanent magnet cylinder, or in addition to iron, to ensure the pressure wheel, mold and the service life of the intermediate shaft.

4. The maintenance of the granulator shall be carried out under the condition of power failure. Regular maintenance, waterproof immersion, rain prevention, leakage prevention, fire prevention and use of mildew feed shall be prevented. Clean and refuel the main shaft of the particle machine every one month, clean and maintain the gear box every six months, and every2-5The bearing of the granulator must be cleaned once every working day, high temperature grease must be added, and the screws of the transmission part must be tightened and replaced at any time.

5. When the material pressing is about to end, mix a little wheat husk with edible oil and put it into the machine for pressing.1-2Stop the machine after minutes to fill the hole with oil so that the next startup can feed the production, which not only maintains the mold, but also saves working hours. After shutdown, loosen the pressure wheel adjustment screw and clean up the residual material.

The above is the content of "how to extend the service life of the sawdust particle machine". In order to ensure the normal working efficiency of the equipment, in the actual operation process, we must strictly abide by the rules in the manual, and do a good job of maintenance when not in use. Work to extend the service life of the particle machine. (How to extendsawdust pellet machineThe service life of?)