What should I do if the sawdust pellet machine is clogged?
Sawdust pellet machine can be said to be a relatively common mechanical equipment now, which occupies a very important position in our production and life. Zhangqiu developed pellet machinery company has been focusing on pellet machine, sawdust pellet machine, sawdust pellet machine, biomass pellet machine for many years.
Sawdust pellet machine can be said to be a relatively common mechanical equipment, which occupies a very important position in our production and life,sawdust pellet machineWhat should I do if there is a blockage?
If you want to know the solution, you must first find the reason. The main reasons for the blockage of the sawdust pellet machine are as follows:
1. One is that the raw materials used for production contain impurities, such as nails, bricks, etc. The solution is to first close the equipment, then open the mold cover, loosen the inner mold nut, then pour out the extruded raw materials, take out the impurities such as nails or bricks, and then tighten the nut.
2. In the production process of the sawdust pellet machine, the sawdust pellet machine is blocked due to factors such as relatively humid raw materials or excessive particle size, and it is very difficult to manually dredge the blockage. For new friends who have just invested in the wood pellet production industry, this is a headache. General large manufacturers will purchase special punching equipment.
In the production process, due to power failure or other reasons, the mold is blocked, especially the small aperture mold is very difficult to clean. The tool for dredging the small aperture mold is more common with an electric drill, but this tool is a waste of time, and it is easy to destroy the smoothness of the mold hole, and it also affects the work efficiency. A more effective method is to use oil to boil the ring mold, that is, use an iron oil pan, put the waste oil, put the plug mold in, completely immerse the plug hole in the oil, and then heat the bottom of the oil pan until the material in the plug hole pops, Take out the plug mold, reinstall the machine after cooling, and adjust the gap of the mold roller. According to the operating requirements of the pelletizer, the material in the plug mold can be quickly cleaned by re-ing.
The above is a small series to introduce“sawdust pellet machineWhat should I do if there is a blockage?"The content, hope to be helpful to the spectator.