How to do sawdust pellet machine mold blockage

There are no more than two reasons for the clogging of the wood pellet machine, one is too fast and the output is too slow, and the other is that there are impurities in the raw materials, such as nails and bricks. Generally, both things happen. The solution is to block the die of the wood pellet machine. The solution is to first close the equipment, then open the mold cover, loosen the inner mold nut, and then pour out the extruded raw material (if it is a brick or nail). Needs to be taken out. After removal, tighten the nut.

Insawdust pellet machineIn the production process, due to improper moisture control of raw materials and excessive particle size of raw materials, the sawdust machine mold will be blocked, and artificial blockage is very difficult. Large wood machine manufacturers will purchase special die punching. The hole equipment is blocked, but for new friends who have just invested in the wood pellet production industry, this is a headache. Today I teach you a simple blocking method.

In the production process, due to power failure or other reasons, the mold is blocked, especially the small aperture mold is difficult to clean. It is more common in pellet production equipment to drill the material with an electric drill, which wastes time and easily destroys the smoothness of the die hole.. After stamping, it needs to be reground for normal use, which affects work efficiency.

Xiaobian believes that a more effective method is to use oil to boil the ring mold, that is, use a ferro oil pan, put the waste oil, put the plug mold into the oil pan, completely immerse the plug hole in the oil, and then heat the bottom of the oil pan until the plug The material in the hole makes a popping sound, that is, take out the blocked mold, reinstall the machine after cooling, adjust the gap between the mold rollers, according to the operation requirements of the pelletizers, the material in the clogged mold can be quickly cleaned by re-driving. Drop and will not destroy the smoothness of the die hole.