When it comes to biomass granulator equipment, we all know that there are many vulnerable parts, including molds, pressure rollers, bearings, etc., but the most vulnerable parts are the pressure roller bearings. In fact, the normal life of the pressure roller bearings of biomass granulator is another 600-800 hours, but many customers need to replace them in 300-400 hours, and even some need to replace them in 200-300 hours. Many of the most important reasons for this are maintenance and oil injection. Due to the harsh environment of the granulation room where the roller bearing is located, the dust in the granulation room will inevitably enter the bearing, and too much bearing dust will lead to butter and bearing connection.
Lift
Biomass pellet machineEquipment, everyone knows that there are many vulnerable parts, these vulnerable parts include molds, pressure rollers, bearings, etc., but the most easily worn is the pressure roller bearing, which is actually normal
Biomass pellet machineThe life of the roller bearing is another 600-800 hours, but many customers need to replace it in 300-400 hours, and even some need to replace it in 200-300 hours. The most important reason for this is maintenance and oiling.
Due to the harsh environment of the granulating room where the roller bearing is located, the dust in the granulating room will inevitably enter the bearing. Excessive bearing dust will lead to the reduction of butter and the bearing contact surface and cannot be well lubricated by butter. In this case, it is versatile to inject more butter. At this time, the bearing needs to be taken out for cleaning, but many users of biomass granulating machines are unwilling to clean the bearing because it is too troublesome, as a result, the life of the roller bearing is shortened.
In addition to maintenance factors, there is also the oil injection of the bearing. As the mold and the pressure roller will produce high temperature when squeezing each other, this temperature will be instantaneously transmitted to the pressure roller bearing. The bearing temperature of the general granulation chamber should be at least about 120 degrees high temperature. The pressure roller bearing in the granulation chamber should be filled with butter. Of course, this kind of butter is not ordinary butter except for the very few external bearings, it is butter with high temperature resistance above 200 degrees. The butter injected by many customers cannot reach high temperature resistance, or the butter quality is too poor, which will lead to poor lubrication effect of the bearing and finally greatly shorten the life of the bearing. In addition to butter quality, there is also the problem of oil injection quantity. Is the more butter injected, the better? If too much butter is injected, it will lead to poor air permeability and poor heat dissipation of the bearing, and the continuous high temperature cannot be dissipated, which is also the reason for the short life of the bearing.
