The reason why the sawdust particle machine can not press the particles

Many customers who make particles for the first time will always have various problems after pulling back the sawdust particle machine they bought. For example, the particle machine can not press the particles and so on. Many customers think it is the reason for the particle machine, but it is not always the case. Today, Xiaobian will take you to analyzesawdust pellet machineThe reason why the particles cannot be pressed.

If the sawdust particle machine is used improperly, the output will indeed be lower than the standard expected output, and the sawdust particle machine will also have the problem of output decline after a long time of use. As a professional biomass pellet expert, we have the following suggestions.

1, raw material moisture is not suitable. For the sawdust particle machine, the raw material moisture is too large or too little, there is no way to let the particles form. Because the sawdust pellet machine is refined by physical pressing the particles, its adhesion is made by the combination of appropriate moisture and pressing, without the addition of any chemical components. Therefore, the moisture of raw materials is one of the important factors affecting the output of sawdust pellet machine. (It is recommended that the moisture of general raw materials be controlled15%-20% within the most appropriate. Of course, the specific situation still depends on the type of raw materials.)

2. The mold compression ratio is wrong. For sawdust pellet machines, compression ratio and moisture are two equally important factors. They are a control in the raw materials, a control in the mold, the two are indispensable, otherwise, the output of the pellet machine will be seriously affected. Therefore, before buying the sawdust particle machine, be sure to communicate with the manufacturer about the compression ratio of the particle machine. Because the compression ratio of different raw materials is also different, if you have a variety of raw materials, you should communicate with the manufacturer to prepare more molds.

3. The gap between the pressure roller ring die is not adjusted properly. When the equipment is tested, the technical personnel of the manufacturer will teach the customer how to use and debug it to avoid the unexpected situation. However, it depends on your actual situation.

zhangqiu developed particle machinery co., ltd. is a professional production of sawdust pellet machine, wood pellet machine, biomass pellet machine and pellet machine production line and other equipment enterprises. Want to know more about biomass pellet machine, wood pellet machine,sawdust pellet machineFor relevant information, you can leave a message on our website.