Sawdust pellet machine operation matters needing attention

Sawdust pellet machine is a kind of mechanical equipment that we often use in the production of our life. Only by mastering the key points of the operation of the sawdust pellet machine can we better use the pellet machine, make it work better for us, and extend its service life. (sawdust pellet machineoperation precautions)

Today, Xiaobian for everyone to explain the operation of the wood pellet machine matters needing attention:

1. raw materials

The size of the wood pellet machine raw material should be controlledWithin 6mm, water content in10-15Between% is more appropriate, such as pressed particles fluffy, vertical cracks, should be appropriate to reduce the moisture content of raw materials; On the contrary, such as pressed particles short, high temperature, cross-section, should be appropriate to increase the moisture content of raw materials.

At the same time, hard (metal) debris should be removed from the materials to avoid damage to the machine and cause accidents.

2. use and maintenance

1, read the instructions: before using the wood pellet machine, you should read the instructions carefully. Understand the wood pellet machine performance, structure, use, and daily maintenance and maintenance.

2. Test run: Before starting the wood pellet machine, check whether the zero parts of the machine are fastened, then start the motor test run, and observe whether the rotation direction of the machine is consistent with the mark and whether there is any abnormal sound during operation.

3. Mould washing: take50Jin chaff,100Jin of fine sand,50The jins of engine oil are stirred evenly, then the punching equipment is used to discharge and grind (through the grinding port) one after another, and the grinding is repeated several times until the template hole is smooth and all the materials are released.

4. Shutdown preparation: Before the new mold is used, the silo of the granulator should be emptied, and then oil-containing materials should be added through the grinding port, and pressed into the mold hole to keep the hole lubricated to prevent blockage during the next use.

5. Particle control: The extended length of the cutter on the material rack can be adjusted to control the length of the particle material.

6. Discharge port: The function of this port is to discharge the surplus materials in the pressing chamber. If the surplus materials are not discharged in time, the hollow shaft bearing will be damaged and its service life will be seriously reduced. Therefore, the discharge port must be unblocked and the discharge situation must be observed during work. If blockage or poor discharge is found, slender objects, such as plastic, wood, bamboo, etc., should be used to remove the blockage, the steel pipe at the discharge port can be removed and cleaned.

(sawdust pellet machineoperation precautions)